Quality Control and Material Test Certificates

Acceptance certificates issued by specialised control units are the guarantee of the highest quality of our products. Depending on requirements and needs, our Quality Control Department provides the following documents

Declaration of compliance with the order "type 2.1" - document in witch the manufacturer declares that the products supplied are in compliance with the requirements of the order, without inclusion of test results.

Test report "type 2.2"- document in which the manufacturer declares that the products supplied are in compliance with the requirements of the order and in which he supplies test results based on non-specific inspection.

Inspection certificate 3.1 - document issued by the manufacturer in which he declares that the products supplied are in compliance witch the requirements of the order and in which he supplies test results. The test unit and tests to be carried out are defined by the product specification, the official regulation and corresponding rules and/or the order. The document is validated by the manufacturer's authorized inspection representative, independent of the manufacturing department. It shall be permissible for the manufacturer to transfer on to the inspection certificate 3.1 relevant test results obtained by specific inspection on primary or incoming products he uses, provided that the manufacturer operates trecability produceres and can provide the corresponding inspection documents required.

Inspection certificate 3.2 - document prepared by both the manufactirer's authorized inspection representative, independent of the manufacturing department and either the purchaser's authorized inspection representative or the inspector designated by the official regulations and in which they declare that the products supplied are in compliance with the requirements of the order and which test results are supplied. It shall be permissible for the manufacturer to transfer on to the inspection certificate 3.1 revant test results obtained by specific inspection on primary or incoming products he uses, provided that the manufacturer operates traceability procedured and can provie the corresponding inspection documents required.

Źródło: European Commitee for Standatdization, EN 10204:2004, Metallic products - Types of inspection documents, Brussels 2004, site 4-5

Acceptance certificates, certificates and declarations are issued upon the delivery in electronic version to a given email address. In case of questions concerning quality certificates, please contact Quality Control Department:

Magdalena Ryszka
Material Test Certificates

gsm: +48 795 557 310
tel: +48 32 762 46 05
fax: +48 32 762 45 54
mail: certyfikaty@geldbach.pl

Beata Erynkwajt
Quality Control Department

gsm: +48 795 557 312
tel: +48 32 762 46 05
fax: +48 32 762 45 54
mail: b.erynkwajt@geldbach.pl